Kenmore 3.8 cu. ft. HE3t Front Load Washer "panel balance error" Questions

Ad

Question about Kenmore Washing Machines

2 Answers

...panel, the ball balance sensor is mounted onto the frame. If the tub spins too wildly, it will hit the ball balance sensor causing it to go UE. But if the back panel is pushed in too much, the tub ...

Ad

...panel and cleaned out the two pipes and the filter. I restarted the washer and still get an F21 error code. The load in there when this happened was big and I don't know if the drum might be off ...

Ad

Question about Kenmore Washing Machines

1 Answer

...panel. Spins to determine load and then shows error. What might cause this and what does this mean? IE means imbalance error//balance load//check tub see if any itams stuck in or around

...back on the switch (either way around) then put screw back to hold the control board. Close up the panel and away you go. Machine thinks it is out of balance that is why it won't start doing

...Balance: Use a LEVEL on the top panel to make adjustments to the lower legs on each corner. Some are screw adjusting and other adjust by lifting the front, sides or back. Try adding fewer items to ...

Question about Fisher and Paykel Washing Machines

1 Answer

...balance switch problem for a F & P "GW 609" washing machine. I think the micro chip is inside the top control panel. Can anyone advise how to replace the switch? What tools are needed? Any ideas on ...

...balance itself. If you get the uneven load error your sensor is probably going out and will need to be replaced. If you pull the washer out it should have an access panel in the rear. Look on the ...

...balance issue. If the error happens only at the spin cycle, check the load distribution. If it happens when the washer is filling, you'll need a multi-meter and the trouble-shooting guide that is ...

Question about Fisher and Paykel Washing Machines

2 Answers

...BALANCE SWITCH ERROR.This means either your switch is faulty or your your control module is faulty.95 % of the time it is your switch which is located under the control module which is under the top ...

Question about Fisher and Paykel Washing Machines

1 Answer

balance switch problem, i found mine was just sticky, if you pull it out (under the electronic control unit, under the top panel) you may be able to find out if its stuck or if it needs a new one, you

Not finding what you are looking for?
Washing Machines Logo

311 questions posted

Ask a Question

Usually answered in minutes!

Top Kenmore Washing Machines Experts

Alexander

Level 2 Expert

171 Answers

Cindy Wells

Level 3 Expert

6688 Answers

vince

Level 3 Expert

2530 Answers

Are you a Kenmore Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...