Kenmore 3.8 cu. ft. HE3t Front Load Washer "elite 3t washer problems" Questions

...Elite HD 3T it keeps coming up Sud and then F35 we replace the pressure switch and clean out pump below and stil have the same problem Cut down on your soap i only use very little soap and it works ...

...Elite HE 3t washer:problem is it fills with water and then I get a flashing FH or HF code. According to the manual that came with the washer in the trouble shooting section for a "FH" code (Water ...

Elite HE 3t suddenly stopped spinning and draining Washer suddenly stopped spinning and draining at the end of washing cycle. I followed the trouble shooting suggestions per manual but without success

Elite 3t is banging in the spin cycle and the plastic ring behind the rubber boot is shredding. Any suggestions? are you using a gel soap if not that may be your problem powder soaps cannot be used in

...elite he 3t washer? This indicates a water problem. Make sure you have both hot and cold water turned on and running to the machine. If pressure is to low on either hot or cold you will also get this ...

...washer stops in the wash cycle with the error code f and h I have the HE 3t and an error code of f flashes at the 9 minute mark. Can any one help with this problem? When I contacted customer service ...

...Elite 3T washer has a loud whistling noise in the spin cycle. ??? Thanks! Hi. When that happens it is often because the drum bearing is starting to go. The first symptom is a loud high pitched noise ...

...Elite HE 3t. Continue to get a dl (door latch) warning and washer will not start. Found the plastic latch/lock on the door is cracked. Assume this is the problem. Any advice and where to order part? ...

elite HE 3t any suggestions? Hi Shaun, I just found (and watched!) a good youtube video which may help with your problem regarding the F11 code, link follows below. Trust this helps, best regards Alan

...elite HE 3T series 4 We are getting an F and then 06 flashing, washer stops in the middle of washing., any suggestions? well i found the answer on browsing through fixya. the following would assist ...