Kenmore 88732 Top Load Stacked Washer / Dryer "ignitors" Questions

ignitor willnot ignite but im getting 120v to it, is my ignitor bad and is there a safety switch on the door that may b bad ? stove top works fine No door safety switch. Replace ignitor. (an older ...

maytag mlg2000aww ignitor flame doesnt go on when started pulled off cover, started dryer and nioticed no flame comes on This dryer uses a hot surface ignitor to light the burner. test for 110 volts ...

Whirlpool gas dryer won't ignite -no heat Not long ago (6mos.)I replaced the two solenoicoilst coils on the gas valve. Do you think that they need to be replaced again. I do not see anything glowing ...

dryer is not heating, where is the ignitor and flame located most models the ignitor and flame are located on the bottom of the cabinet, below the drum, start the dryer and wait for a few minutes, see

Kenmore gas dryer 110.97278100 won't heat I have a Kenmore gas dryer 110.97278100 that does not want to heat up . I cheched for power on the ignitor and it was only 18V, then I checked for power on ...

frigidaire gallery dryer I have a Frigidaire gas dryer GLGQ642CAS4. After the timer control is set and the start switch turned on. The ignitor will glow, the gas will ignite, but only stay on for ...

how to clean, reposition, or replace the ignitor/thermocouple Disconnect the power source. Using a Q-tip soaked in rubbing alcohol, wipe the front of the ignitor/thermocoupler

gas oven stopped working it heats up to 100 like it is supposed to then there is no whoosh sound and no futher heating .yes there is gas. it did this once before and then worked like it was supposed ...

gas dryer is not getting hot. ignitor replaced. gas line replaced. It is either the 2 gas coils on top of the gas valve in the dryer, or the flame sensor on the side of the flame tube. If the ignitor ...