Kenmore 3.5 cu. ft. Front Load Electric Washer "power washer starts dies turn" Questions

...power outage, call electric company. Water supply faucets are not turned on. Turn on water supply faucets. Motor is overheated. Washer motor will stop if it becomes overheated. It will automatically ...

...power and all he lights turn on but when i hit the start button nothing happens!!have checked all the water cnnections etc. and everything is clear and fine!!ahh helpppp..... quite likely the motor ...

...power?? hi can any one help,my hotpoint wd63 washer dryer has died,its only 4 years old. for the past month or so its been not starting properly after door is shut it didnt turn on firsr time and ...

...washer at the time were sopping wet, so it did not complete the spin cycle before dying. it would not let me reset it and would not run a cycle. a repairman tried putting in a new circuit board, but ...

power is unplugged form the wall. Gently pry open the casing and you will see the fuse within. The ends of the wires just pull off (gently) and then you have the fuse. Tomorrow I go on a fuse hunt and

...washer WITHOUT Soap. Suds code still shows, Washing continues to agitate and try to spin. I tried to put it through again without soap, same thing happened again, SEVERAL times. The only thing I have ...

...washer died and would not turn on in the middle of a wash cycle. Absolutely dead. I disconnected it from power and opened up the front panel on which all the control switches and knobs are mounted. ...

...washer does not fill. If water is not getting into the machine, check the following: To start cut power to the applianc3e for five minutes, this can fix a jammed timer control. Check if the hot and ...

...power indicator) in the front of the machine is always off now, even when I turn the machine on and it seems to be otherwise working fine... Any assistance would GREATLY appreciated. Many thanks in ...

...washer or reconnect power. 5. Activate the Console and Indicators Diagnostic Test mode to verify repair. 6. If indicators still do not light, the machine/ motor control has failed: Unplug washer or ...