...HE3t washing machine is showing the F06 error. Is there any way to tell for sure if it is the motor ar the MCU? Hi Thanks for using FixYa. Error F06 in your whirlpool duet indicates that the control ...
Question about Kenmore Washing Machines
motor speed control board) and ccu(central control unit). i recommend you to ohm out the motor. most likely its your motor speed control located at the bottom left of the washer good luck. replace the
...Motor Control Unit (MCU) cannot be sent correctly. Communication between the main board and the motor control board is not being sent correctly. This could be a bad main board, motor control board or ...
Question about Kenmore Washing Machines
...HE3T front load. It gets down to 6 min then stops and flashes between 06 and F. I think its the final spin cycle that doesn't work. It does everything else fine. Sometimes if we cancel it and restart ...
...motor). You can check for this failure by unplugging the washer and then pulling the MI3 connection on the CCU. The wiring diagram below has the MI3 connection highlighted in red. The connection has ...
...motor control unit. A common problem is that the wiring connection jiggles loose or gets corroded. Unplug and reseat the connector at the control board, and this may solve the problem. Also look for ...
...Motor MCU Wire harness That code comes up with quite a few things that are never the problem. but 1 of them on there is the control unit. if you take the top off, there will be three screws on the ...
...HE3T Front Loader Washer. We replaced the Machine Control Unit and did not fix the problem? The error is an indication a motor speed problem. You will need to check the following: - Check the wiring ...
...HE3t Front Loading Washer I ran a cycle before bed and the machine seemed to run forever. This morning I found the door won't unlock. The "controls locked" button is lit. I attempted to run another ...
...Motor control unit (MCU). If that is fine then check the connection between the MCU & central control unit (CCU), replace the part that has gone bad. Please do rate the solution if the issue is ...
459 questions posted
Usually answered in minutes!
3,839 Questions
3,158 Questions
2,098 Questions
1,642 Questions
1,023 Questions