...propeller is broke off. If I get a new pump how do I disconnect the wires? Do they just unplug? Thanks Steve Yes...there is a simple disconnect plug on the drain pump. The pump can be purchased at ...
Question about Kenmore Elite Washing Machines
...drain pump itself. I was able to feel that the pump propeller is free of any obstruction, as it turned freely. I replaced the drain filter and outside drain hose, and started an empty wash load. It ...
...DRAIN MOTOR PUMP it could be clogged with debris and lint , locate the MOTOR at the bottom , usually its a small motor with propellers that the DRAIN HOSE is connected to it , gonna need some rags , ...
Question about Kenmore Elite Washing Machines
...propeller located where the DRAIN hose is connected , hope it helps AJ there is also a drain cleanout. take the 3 screws out on the very bottom of the washer. slide the bottom panel down and you will ...
...not. need to check the DRAIN MOTOR PUMP it could be clogged with lint & debris , usually its a small motor with propellers located at bottom where the DRAIN hose is connected, hope it helps , ...
Question about Maytag Washing Machines
...drain motor will not turn propeller Don't try to fix it yourself it could cost you more in the long run but if the shaft isn't turning the propeller more than likely there is something in the pump ...
...or spin need to check the DRAIN MOTOR PUMP located at the bottom on a side with a little propeller , it could be clogged , take it out , clean it , replace it back and try it again, hope it helps ...
Question about Kenmore Elite Washing Machines
...need to be relaced. Try unplugging the connector that goes to the pump and plugging back in. Also try tapping the the motor part of the drain assembly while in spin cycle before replacing. Good
...DRAIN MOTOR PUMP located at the bottom side , the motor with the propellers , it could be clogged , get some rags and remove PUMP to remove any lint or debris , replace and give it another try , hope ...
...need to open washer and check the DRAIN MOTOR PUMP , usually gets clogged with lint and debris , usually located at the bottom side , small motor w/ propeller ,where the drain hose is connected, ...
4,938 questions posted
Usually answered in minutes!
1,023 Questions
0 Questions
69 Questions
45 Questions
20 Questions