Kenmore Elite 45986 Front Load Washer "mark 2" Questions

Whirlpool Duet dryer - "burn marks", "out of round" drum Whirlpool Duet dryer - 2 1/2 to 3 year old dryer started leaving "burn" marks on clothes. Service tech replaced felt seal. Burn marks stopped. ...

...2 screws on each end on top. Remove the detergent drawer. Remove the torx screws behind the detergent drawer. The control panel will now snap off, pulling from the top and lifting up. Once freed, ...

...2 pins then pull out 5. Put the connector back in. 6. Replug in washer and watch it work. 7. Get a sharpie an mark "F/DL" above the connector -- you will be glad you did 8. Put top back on 9. Comment ...

my kenmore elite with calypso motion top load is leaving black marks on my clothes and they are getting caught between to bottom plate and the side wall, the plate is fairly new. 1. UNPLUG THE WASHER.

2. Remove the outer portion of the door bellow. This is the gray rubber boot around the door. Feel around the edge of the door bellow where it attaches to the front of the washer. You will find a wire

2. Locate and remove the retaining screws in the back of the control panel. With the screws removed, the control panel will lift from the back first, then off. NOTE: Be careful when lifting the panel,

2. Locate and remove the retaining screws in the back of the control panel. With the screws removed, the control panel will lift from the back first, then off. NOTE: Be careful when lifting the panel,

...wash tub and install clamp. There should be instructions that come with the door boot with guide marks to ensure you align it correctly. Once you have the boot in place, tighten The clamp enough

...wash tub and install clamp. There should be instructions that come with the door boot with guide marks to ensure you align it correctly. Once you have the boot in place, tighten the clamp enough