Question about Kenmore Elite Washing Machines
what does an error code 11 mean? I have a Kenmore Elite model 110 45996 4000. thank you - Susan Hi from retired Englishman in SW France, For Kenmore (manufactured by Whirlpool) washers F11 decodes as
err 7 showing and not spinning, all wires connected to motor? Hi from retired Englishman in SW France, Haier 'err7' decodes as 'motor overheat protection or is damaged' which points to an engineer ...
f-08 code Hi from retired Englishman in SW France, Indesit 'f08' decodes as ' heater relay stuck' and the advice is 'check PS (power supply)connections for the heater, wiring and module'. ...
Question about Hotpoint Washing Machines
My hotpoint ultima is not heating, the drum spins. could you advise what the problem is Hi from retired Englishman in SW France, For most Hotpoint (and other named) models there is a common problem ...
f10 Hi from retired Englishman in SW France, Hotpoint (Indesit) 'F10' decodes as 'pressure switch not sensing'. Apparently a number of problems occur because of loose connections on ...
My hotpoint wt741 washing machine hsa stopped doing full cycles and flashes an error message F-02 Hi from retired Englishman in SW France, 'F02' for Hotpoint/Ariston and Indesit (who makes them) ...
Question about Kenmore Elite Washing Machines
error code le on washing machine wm-1480fhd.... drum stops spining in certain directions and then stops with the error code :LE Well, according to the LG error look up table: LE Locked motor error. ...
I have a front load washer about 6yrs. old. Sometimes it stops before the cycle is over, beeping with F-11 flashing in the window. What is F-11? It restarts after I push a bunch of buttons to change ...
my new hotpoint washing machine on occassion is showing fault F-01 can you tell me what this means I have not been able to wash a load becuase this is showing up. Sometimes if i switch it on and off ...
What does the code PE mean ? PE indicates PRESSURE SENSOR ERROR. Mostly the sensor must have failed before replacing it just confirm the connection to the sensor are tight enough and if they are ...
4,938 questions posted
Usually answered in minutes!
1,023 Questions
0 Questions
69 Questions
45 Questions
20 Questions