Kenmore 63942 Dryer "test tumble capacitor" Questions

tumble dryer motor capacitor. Old one has 4 terminals but the pairs on each side are soldered together on to one joint. The replacement has 4 seperate terminals. As long as each pair of wires go to ...

...motor will not start if this capacitor is not in circuit or faulty. The capacitor will need to be tested using special equipment. If you remove this for testing be VERY careful because the

...tumble dryer: model 252dtd Replaced the thermofuse 3 times.will not stay hot for long Any ideas? The 10mf ac cap tests 2,4mf. is this a cause ?Drum belt tension is good and motor turns free. make ...

...tumble,it will only start if I physically push the drum,is the capacitor at fault? might be could also be the start relay? u can also buy a 3 in 1 hardstart kit pretty cheap more cheap than buying ...

...tumble. The problem is that it does not start tumbling at all. I have to manually turn off the dryer because I start smelling something burning. Please help! Kathy Dryers have a drive belt that turns ...

...tumble drier, that has just stopped working, no power seems to be getting through, but the fuse is working. Electric dryer no start does nothing Check dryer Terminal block prongs both outside prongs ...

tumble dryer won't work at all, done all the checks water carrier, cleaned out fluff in drum and the one at the bottom, changed fuse and still nothing. Electric dryer no start does nothing Check dryer

...tumble,The problem might be from three different reasons,which are described below,check these: 1.BELT; Dryers have a drive belt that turns the clothes drum. If the belt breaks, the drum stops ...

...test and fix it. God bless you Belt Dryers have a drive belt that turns the clothes drum. If the belt breaks, the drum stops rotating. Then you need to replace the belt , and often the idler pulley, ...

...tumble dryer is not working. Power is getting into machine. The 'Mains - on' light comes on. No other lights eg. at 'Low Temp', 'No Buzzer', 'Start' buttons come on. Is it a control board issue and ...