Kenmore 63942 Dryer "16 inches meter" Questions

...16 or 1/4 inch nut driver to remove the rear panel. Also, you will need to detache the vent. Once the back is off, toward the bottom you will see your element. Attached to the housing where the ...

meter if you could give me a place to start.. or send a diagram.. Frigidaire ? built (Frig, Westinghouse, Tappan, Gibson, Kelvinator): most newer models tuck theirs above the large round element ?pan?

...meter,pull at least one wire off the part you want to check,if you get ant reading the part is good,if it stays on 1 the part is bad,it's that simple,also most parts either work or they don't so if ...

...inches up from floor you'll see a white thermal fuse part 3392519,check it with meter,now go back to the filter duct,take out the four screws and clean it out,bad air movement will pop the thermal ...

...meter,now touch the leads to the fuse,if it stays on 1 the fuse is bad,if you get any other reading then the fuse is good,if it's bad change it out but it popped because the dryer is running to ...

...inches in from the side,just pop the top near the clip and make sure you still have the two screws out that are in front of the lint filter,next there are two 5/16 inch screws one on each side that ...

16 inch screw one on each side a few inches down from the top,remove them and disconnect the door switch wires on the right side,a small screw driver can be slid in between the plastic to separate the

...16 inch screws on the inside a few inches down from the top,one on each side,remove them and the door switch wires,get a small screw driver and stick it into the connector to separate it,and remove ...

...inches in from the sides of dryer and pop up the top,next remove the two 5/16 inch screws one on each side of front panel and unplug the wiring harness in the top right side,you might have to stick a ...

...16 inch screw one on each side that holds the top of the front panel on around 2 to 3 inches down you'll see them,remove the door switch wires and then pull up on the front panel and remove it,with ...