...ok since it will not be needed for 4 wire. First things first. You need to get the terminal block put back in its proper location. The 3 wire cable must not have been properly clamped allowing the ...
Question about Dryers
...replace the plug *only* on this range with a 3-prong plug? I believe I need a copper strap to ground from the neutral wire on the back of the range to the frame, but I want to know if it's OK to just ...
...replace a 3prong plug with a 4prong plug Ok, so you currently have a three prong cord on your dryer? Your house has a 4 prong receptacle? Ok so now you've purchased a 4 prong dryer pigtail? Be sure ...
...replace the 3 prong plug with a 4 prong plug for our new house. The wires on the dryer aren't color-coded though, and there's no notes which is hot, ground, or neutral. How do I hook the 4 wires to ...
...OK. Heater coils can be checked by; 1. Remove the wires off the coils. 2. Using a multitester, set it at 1 x 10 Ohms. 3. Place one test prong of the tester at one end of the coil, and the other prong ...
...4 prong. That is, the dryer was originally "designed" for a 3 prong. This means you'd have to "retrofit" it a bit. Take a look at this pic... ( I made this for someone else, so please disregard my ...
ok...until it ran awhile. My wife informed me that when she pushes the button to start, it's making the "start" buzzer-type noise longer and louder....now, it seems to do it for 3-4 seconds before the
Question about Miele Dryers
...OK. Tried timed and sensor runs with no luck. ELECTRIC Dryer no heat or little heat, or shuts down to fast: Check your venting and lint basket. Check blower for lint build up and blower wheel ...
...OK switching them out. Remove safety plate (usually attached only by 1 or 2 screws) Remove old cord and restraint with a hand or cordless drill. I find that I tend to strip these softer screws with ...
...OK, back to the thermal fuse. Make sure dryer is unplugged, disconnect the two wires on the fuse, You will set the meter to read ohms on the lowest setting. The setting is usually RX1, or RX1K. Touch ...
18 questions posted
Usually answered in minutes!
1,329 Questions
1,410 Questions
750 Questions
524 Questions
182 Questions