Kenmore 79012 / 79014 / 79019 Gas Kitchen Range "test oven electric ignitor" Questions

...test the wire leads that i connected the new ignitor too and and have power from both. Is it possible that I purchased a bad ignitor? Are there other tests I should be doing to diagnose this problem? ...

...oven, you can see the ignitor and test it to see if it is getting 120V. If it is getting voltage but not glowing, the ignitor will need changed. I hope this helps you. Please let me know if I can ...

...test should first shut the gas off next locate the oven ignitor or bake ignitor and you will see two wires that go to the ignitor clip around one of the wires should be reading 3-3.3 amps any less ...

...oven. 1) Confirm if its just the bake or both bake and broil that doesn't work. 2) If its just the bake you will most likely need to replace the bake ignitor. 3) If its both you need to test for ...

...oven for 15 minutes and it will work again. This is a GAS range The problem is usually the ignitor not reaching the correct amp draw .When the ignitor does not reach the correct amp draw it may allow ...

...test the broil, and see if that works. (I would guess that it does) Most likely the oven ignitor (part number WB13K5058 ) needs to be replaced. It is located under the floor of the oven right next to ...

...oven still won't. What could be the problem. did you do it your self or did you have some one else do it for you? I ask the question because the electricity most be unplug before you do it, If any of ...

...oven. The thermocouple which tells the gas valve to open, once the ignitor has reached the proper temperature, so if the thermocouple isn't working, the gas valve won't open. Here's a link that you ...

...oven doesn't. No glow from ignitor or gas smell. Does ignitor need to be working for gas to flow? Can you manually ignite? Thanks Ignitor needs to be working for the gas valve to open. If the ignitor ...

...oven gets hot (set to broil) or cool (set to 0 to 440 degrees) Well if called out for a look see I would do a amp draw test on the ignitor first. Under 3.2 amps and that weak ignitor is gonna cause ...