Brother IntelliFAX 4750 Plain Paper Laser Fax "replace fuser unit" Questions

...fuser unit (hot section or hot rollers in the back) need to be replaced. Usually when the gear has worn or failed the fuser rollers are also worn and need to be replaced. The gear can be replaced ...

...replace the fuser itself but it is a lot of work. This same fuser is also used on the Canon ImageCLASS MF3110, MF5530, MF5550, MF5730, MF5750, and MF5770 units. I was lucky my fuser was fine, but the ...

...I would remove it and resit it and then see what happens, if not replace Fuser, As worse it could be down to the lower voltage power supply but as yet i have never had that problem! hope this ...

...unit (fixing unit) not registering heat requirement. The heat roller or the thermistor sensor is defective.Remove fuser and check roller, if good replace sensor, reinstall fuser and reset

Fuser Replace Procedures what is the procedure for replacing the fuser/fixing assy. u its very difficult to replace fuser unit

error code ##322 get code ##322 that code is a fixing heater code, may need to replace fuser heat roller its a fuser unit that has gone! can the fuser unit be replaced?

...replace it the fuser thermistor makes contact with the heat roller. Normally they are in the middle of the roll. If you are experiencing a fuser error. Most likely the upper fuser will need to be ...

...replace fuser unit.try once to reset with the code. if unit seems became OK. if not 1.disconnect power.2.remove the bottom cover.3.dis conn.2 thick cable connectors(fuser lamp) and small white ...

...trays, took toner in and out, tried delete and clear buttons E000 means your fuser section is having problems.sometimes you can reset but may need to replace fuser unit. How do you reset fuser

...fuser unit will need to be replaced. It's possible that the heat lamp or thermostat of the fuser has failed, but getting those individual items could be difficult. The fuser unit should still be ...