Question about Cozy Heating & Cooling
...wall furnaces are kind of touchy. It may be larger, BTU wise, and the vent pipe may need to be enlarged. If this is a big job, and a bit too impractical, check the vent pipe, make sure its in good ...
Question about Empire Heating & Cooling
...vent to pass through the wall, but there is a metalbestos chimney, ready to accept a single wall adapter and reducer for the heater's 4" exhaust vent. Comments on this off-label installation idea? No ...
...wall heater a month ago "converted" for propane. It worked great for aprox a month now it wont come on. The piliot is lit but just wont come on? check thurmostat. check low voltage. check ...
...vent safety limit switch" which is a high temperature limit. It gets hot enough to trip over time because you do not have proper venting. It is a safety switch and SHOULD NOT be disabled - instead ...
Question about Williams Heating & Cooling
...its cycle goes off pos high limit heater wont keep running williams wall heater Check the flue, and supply vents and return air filter, obstruction of air is why unless you have a cracked
heater will run for 20 to 40 min cycle fine and that shut completely off...piolt and everything...relight same thing over again... it could be that heater is not venting properly and this will cause ...
...vent. The flames under pilot light will not come on. Any suggestions. Tie red and white wires together after removing thermostat from wall, if unit comes on replace thermostat, if not check limit ...
wall furnacein very old apartment building. After we got the old furnace out and new furnace in place we realized that to make the new furnace fit properly the bottomplate of the furnace would have to
Question about Holmes Products Heating & Cooling
...wall) drafty area. Possible limit switch. It is rare that the anticipator in the t-stat is a problem unless it is not set for the correct heating system. If it is an old school mercury no one would ...
...wall unit; there is a burner on each side; the pilot is split with a flame going to each side. the pilot flame now reaches to both burners, the thermocouple glows red, and it works. but now i'm a bit ...
192 questions posted
Usually answered in minutes!
64 Questions
59 Questions
57 Questions
21 Questions
11 Questions