Bernina Activa 130 "thread caught top loading bobbin" Questions

...thread gets caught underneath when trying to bring up the bobbin thread try changing the needleif it's a top loading bobbin make sure the bobbin is turned the rightwayif it's a front or side ...

...thread it gettign caught . what wrong with it how do i fix it The top thread breaks 1. the needle thread is not threaded properly 2. The needle thread tension is to tight 3. The needle is bent or ...

...thread or lint caught underneath the needle plate.Make sure that the thread is not too old and inclined to knot.:-) Ditto what Ruth posted... check the bobbin thread does not escape from the bobbin ...

thread caught on the front, right corner of the feed teeth (and it will just be caught on the corner) your feed height needs to be adjusted properly. When the teeth get too low they are actually below

thread caught anywhere in the bobbin casing, load the thread. Then dangle the bobbin housing from the thread end. A gentle pull (more like a ****) on the thread should allow the bobbin casing to slide

one complete rotation. Watch to see if the top thread is caught by the rotation hook and slips all the way around and back over the top of the bobbin tray, or if it snags on it somewhere.... Good luck

...thread gets caught up and makes a mess and stops the machine. Also, the bobbin case doesn't sem to fit in the machine properly, though it fits alright without the bobbin in the case. Is this a top ...

...caught in the thread knot, pulls to the side and breaks but if it gets seriously caught it can pull the needle bar out of place. You cannot put the needle bar back in place yourself - it's a job for ...

...thread. also please brush clean bobbin holder area and check for any threads caught there. now a drop of quality clear machine oil in middle hole and gently run for 30secs to work in. do this every ...

...caught in the bobbin race area. Maybe even unscrew the plate and take the whole bobbin race assembly apart and clean well. Once that is done put back together then re thread machine. Next I would ...