Question about Husqvarna Sewing Machines
...remove the rear cover by taking out two screws on the back cover and a screw at the lower rear corner on the side. With this cover removed you can see most of the internal levers and mechanism and be ...
back cover has to be taken off first before you can get at screws for the front cover. Typically there are 5 screws on the back cover that have to be removed and 2 in the bottom of the base. Note that
Question about Husqvarna Sewing Machines
...remove the front cover of my Husqvarna Viking 630 sewing machine. Any advice welcome. I have already removed the back cover. These are very well built machines. I will always suggest having a trained ...
Question about Sewing Machines
...tried the cleaning oil and hair blower Probably a stuck slide block which is common on these machines. Usually not a difficult repair but the back cover needs to be removed and the mechanism
remove housing on viking se I removed all the screws on the back of the machine but can't get the housing off.Help there are six screws on the back and 1 on the free arm cover after that there are two
Remove the stichplate and snap out the plastic cover over the thread cutter (left most end of machine). This exposes the thread cutter mechanism. You should then be able to position the knife arm back
Question about Husqvarna Sewing Machines
...back cover off to clean it but cannot get it off. I removed the small phillips head screw under the handle but there is another screw keeping the cover on. It is under the cover by the light and ...
Question about Husqvarna Sewing Machines
a Viking Husqvarna Classica 100 sewing machine. Assuming I need to remove front cover. How do I do that? Sounds like a bind in the slide block which you get to from the back. It is near the hand wheel
...cover off (Left side aound light) and take a look, presser bar may have over extended and fallen off the lever connection...needs to be taken even higher as the lever is eased back and reset to ...
Question about Husqvarna Sewing Machines
...remove the screws from the back side of the machine. You'll need a set of Torx tools (from the local auto store). Also note that the plastic cover pieces snap together and will have to gently pried ...
214 questions posted
Usually answered in minutes!
64 Questions
435 Questions
165 Questions
144 Questions