Bobbin thread is pulling to the top, using embroidery needle, bobbin thread and proper thread on the top. As far as I know the machine is set right. This might not be the right place to ask, but am ...
Question about Kenmore Sewing Machines
...thread a bobbin,sears Kenmore model 158.17031 Place both the bobbin case and the bobbin on the table in front of you. Have the open side of the bobbin case facing up and the bobbin with the thread of ...
Question about Bernina Sewing Machines
bobbin thread keeps breaking. Please advise what may be causing this. Thanking you. My faithful 730 Bernina is currently breaking the bobbin thread. Can you help Roz Bobbin thread breaks 1. There is a
...thread end the bobbin should turn clockwise. Never hand-wind bobbins. Instead, use the accompanying bobbin winder which is attached to most machines,bobbin casings must be oiled regularly to prevent ...
Question about Singer Sewing Machines
bobbin thread First check that the needle isn't bent. (The simplest thing is to try a new needle.) Next check that you have a correctly wound and installed bobbin. The hole should be facing up and
...bobbin thread. The case should NOT move. Quickly let your hand drop 2-3 inches to let the bobbin case free fall for 2-3 inches, the bobbin case should move slightly then stop. It moves because it ...
...bobbin thread breaks too much. How do I fix it. Be sure you are using the correct bobbin for your machine. Even though it appears to fit the bobbin case, if it is the wrong bobbin, it could cause ...
...bobbin thread coming through (currently using pre-wound ones bought from Husqvarna dealer in England). I was doing some embroidery today and everything was okay until I had to change the bobbin. As ...
re-orienting the bobbin inside the case, altering insertion of the bobbin case, ... no success. Tension for the bobbin thread may be wrong. Adjust the tension for the bobbin thread, not the top thread
Question about Sewing Machines
...bobbin thread up to the top? Install a brand new needle. Remove the thread. RAISE the presser foot and rethread from the beginning--allows the thread to seat completely in the upper tension disk. ...
67 questions posted
Usually answered in minutes!
49 Questions
48 Questions
25 Questions
19 Questions
8 Questions