Husqvarna Viking 1 "set needle position sewing" Questions

...needle so it is centered when it is set to center position. Now, it is in a right side position when set to center. Don't know the make/model machine. The following may be helpful: Sewing Machine ...

...needle and re-tighten set screws.  This knowledge is vital for effective sewing machine repair. Once the timing has been reset, conduct thorough test sewing on the sewing machine to make sure ...

Set the dial to "3" position. Sew the right side. Raise the needle. Select the pattern selector dial that is solid green on the top and bottom. Set the dial to "4" position. Sew 5-6 stitches and raise

set the timing with needle in centre stitch position remove bobbin cover needle plate and bobbin assy .turn hand wheel towards you until needle at lowest position, watch the rotating hook, as you turn

...set my needle to stop in the down position instead of the up position? I would like to applique and need my needle to stop down when I release the pedal. Please correct down position and remove the ...

...set of three buttons above the needle shaft is the needle up/down button. If you press it when the machine is NOT sewing, it will reset it to stopping with the needle UP instead of DOWN. In other ...

...NEEDLE. TIGHTEN SCREWS. IF NEEDLE BAR IS OUT OF TIME. BRING HOOK TO CENTER OF NEEDLE AND LOOSEN SCREW IN LEFT COVER. RAISE OR LOWER NEEDLE BAR TO SET 3/32OF AN INCH. THE 3/32 MUST BE VERY VERY

...the needle bar? And what do I need to do to fix it myself? It appears the machine has a variable needle position. Perhaps that was accidentally bumped thereby setting the needle at the left

...significant:

...needle position is set to the left position. You need to change the setting so the needle is centered. Also, make sure you do not have a zig-zag or decorative stitch selected. While in this setting, ...