...put string into the shuttle I take it you have a shuttle with a bobbin inside. Remove bobbin and attach it to the bobbin winder by the balance wheel, wind bobbin and while holding shuttle point ...
Question about Sewing Machines
PUT THE BOBBIN IN BEFORE YOU START TO SEW. Sounds like you are describing the hook. Perhaps the owner's manual would be assistance. We don't know the make/model of your machine so are really unable to
put the hook cover on (machine still on its back) with the tabs for the twist locks pointed out. Needle gaurd to the top of the machine. Snap the twist locks in place and viola! Kent here your shuttle
Question about Necchi Sewing Machines
...put bobbin shuttle hook back into the machine? This is the part of the machine where the bobbin case with bobbin is inserted into. You are in luck, Wren Paasch posted some cool videos that may be ...
...put the bobbin case on to the shuttle, now hold just thread and with a youo motion shake the above and the shuttle and bobbin case should slide down the thread about 12 to 24 inches for correct ...
put it together with manual but the needle hits using the way they showed and if i adjust to different way it will not pick up bobbin thread with top thread am at wits end. The bobbin should be placed
...Put the bobbin into the case so the thread is feeding clock wise and through the guide on the case. Lift the lever to hold the bobbin in place. Insert the bobbin case into the race/shuttle, still ...
...bobbin case. 2. Push levers sideways of the shuttle assembly and liftshuttle and shuttle race cove out by the center pin. 3. Clean the shuttle race of any lint or small particles of thread with a ...
Question about Sewing Machines
2 levers to release the cover plate. Pay attention to positioning so you can put it back together. Remove the shuttle, then the bobbin cover and see if there are any knots of thread getting in the way
...bobbin and put it in the shuttle and when I try to load it it just falls out If it is an older model sewing machine, there is a little flap on the bobbin shuttle. Pull out on the flap when you insert ...
39 questions posted
Usually answered in minutes!
49 Questions
48 Questions
25 Questions
19 Questions
8 Questions