Question about Husqvarna Sewing Machines
...feed teeth I am unable to raise them manually with the dial. They do raise with a mechanical "clank" as I begin to sew. The feed teeth are on the extreme right off the slot openings. Shouldn't they ...
Question about Husqvarna Sewing Machines
...feed teeth are lowered when you turn the dial on the front of the free arm to the left . Turn the dial to the right if you wish to raise the feed teeth. The feed teeth will raise as you begin to sew. ...
...Feed Teeth to the raised position, and with your forefinger pop up the Feed Teeth (underneath the needle) to the raised position. You will here a click... and you are set to go. Reassembly your ...
...feed teeth start to rise right when the needle starts to rise and fall right when the needle starts to go into the fabric. Make the setting the same. i.e. when the feed teeth start to rise, how high ...
Question about Sewing Machines
feed teeth won't raise back up after sewing buttons Cleaned and turned machine on and off. It usually re-raises the feed teeth. The Sapphire will not raise the feed untill it makes one or two stitches
...feed. Teeth do not raise, to low how do I raise them so macine will grab fabric Here is a link to page 22 of the manual. It shows you where to flip the lever to raise the feed dogs. If your feed dogs ...
Question about Husqvarna Sewing Machines
feed teeth are coming up above the needle plate. Remove the presser foot and unthread the needle, then rotate the handwheel (always towards you, never away from you) and check to see if the teeth come
Question about Singer Sewing Machines
...what I may have done - Help! the bobbin has nothing to do with the feed teeth however it is possible that at some point you moved the forward /reverse knob lever to middle where the teeth will not ...
...feed dog. Which one adjusts it higher? I would not advise raising the teeth any higher unless they have dropped down, with the teeth fully up crouch down so the teeth are in your eyeline and they ...
...feed teeth will not lower. I move the dial and they stay raised. Even when the embroidery attachment is on. Can I manually lower the feed teeth? If the machine has been taken apart it may have been ...
754 questions posted
Usually answered in minutes!
49 Questions
48 Questions
25 Questions
19 Questions
8 Questions