Janome Jem Silver 662 Mechanical Sewing Machine "machine bottom loop loose" Questions

...Bottom side loops are very loose. How to adjust? Looping stitches can be caused by a few different factors. Make sure that your machine is threaded correctly. If the top thread or bobbin thread is ...

loose stitch with loops on top of material i got the right needle and bobbins what do i need to do i have ls 2125 brother General rule of thumb is this.. If it loops on the bottom the problem is on ...

...loop up? the bobbin or top threading?? It's loose but the bottom looks great General rule of thumb:: loops on the bottom, problem on the top. loops on the top, problem on the bottom. It sounds like ...

...bottom, problem is on the top.. When threading your machine, stop just before you thread your needle, put the presser foot down. Try pulling the thread. If it pulls easily, the thread is not thru the ...

...the top thread is too loose. Think of 2 little elves playing tug of war in your machine, one on toip and one underneath. If you have loops on bottom, the top needs to pull harder (tighten top

...bottom are loose and loopy? Check your upper threading. Make sure it's between your tension discs. Remember loops on bottom, something is wrong with upper threading/tension. Loops on top something is ...

...tried tightening the screw, but made no improvemwnt. Cleaned bottom of machine, took off cover and dusted out. Still too loose. Anything else I can do? Hai, Please try to change the New bobbin case

...loose If your bottom stitching is loose ie looping it is normally the top tension that needs tightening. Just adjust the tention on your cotton on the top front of your machine. Hope this

...loose or the bottom is too tight. With loops that big its probably the top is too loose. 1st look in tension disks, there is likely a chunk of thread in there. A toothpick is handy to dig it out (the ...

loose stitches on bottom I have a Singer Fashion Mate Model 362 bought in 1976. I have adjusted the threading tension, adjusted the bobbin tension and there was no difference. I'm pretty sure I've got