...NEEDLE BAR 3/32 OF AN INCH ( OR 3 MM FOR A METRIC RULE) .HOOK POINT SHOULD BE IN CENTER OF NEEDLES WIDTH. LOOSEN THE 2 SHAFT SCREWS SLIGHTLY,TURN HOOK TIL CENTER OF NEEDLE. TIGHTEN SCREWS. IF NEEDLE ...
Question about Sewing Machines
...needle system is not being used. 3. The "little wire" is bent. If this is the culprit, it probably means that one of the above three scenarios was compromised. The best solution is to have your ...
Question about Janome Sewing Machines
...Needle bar change over phase.) 3. Remove the stationary cover then turn the hand wheel to 270°. Using a 2.5mm hex driver, turn the silver gear on the needle-change step motor to move the head from ...
...towards you until needle at lowest position, watch the rotating hook, as you turn hand wheel slowly to raise the needle 3/16" the hook should be exactly behind the needle and be just above the ...
Question about Janome Sewing Machines
...have 3 position settings (left, center, right), and some newer machines have a variety of needle position settings. Whichever your machine has is what you can use. ... move the material to the
...3)Loosen the needle set screw with hexagonal wrench Reverse order to install new needle. Click this link to download the users manual for your machine --->click here<--- Please take the time to rate ...
Question about Singer Sewing Machines
...needle position to "3" middle confirm that the left right zig zag is not hung up. remove pressure foot completely and check for clearance remove presser foot plate and check for clearance remove ...
Question about Bernina Sewing Machines
...3. With the needle lifted out of the stitch plate, gently push the head frame in the desired position so as to position the needle center in the stitch slot. (you will find some resistance here so a ...
...hit the reset and this should realign back to center some machines have a 3 needle setup this is also a make sure that needle is positioned in middle 3 needle setup is for the thicker decrative ...
Question about Sewing Machines
...3 needle positions, machine only sews in the center needle position. why will the machine not sew on the right or left position? Hopefully it is a bent needle. Replace the needle first. If that ...
259 questions posted
Usually answered in minutes!
565 Questions
102 Questions
90 Questions
79 Questions