PfaFF Tiptronic 2030 "sewing machine slowing down making" Questions

...sewing machine is slowing down during sewing and then goes back to normal, there are a few possible causes to consider: Tension Issues: If the tension on the thread is too tight or too loose, it can ...

sewing machine stops sews a minute slows down or stops then starts up when is start to sew machine starts sewing then slows down or stops, i step on pedal like if I were driving pumping it to keep ...

...you are sewing if it's slowing down sounds like something may be holding it back, only other thing that may cause something would be internally if not the feed dogs. let me know hope this helps ...

...sewing a while. it could be the motor or the power cord or the foot pedal, check to make sure the power cord and the foot pedal are connected correctly to the machine.if they  arethen the ...

...sewing machine. The motor, makes a strange high pitched noise, it has now slowed doen so much I am unable to use it. It was working fine. It has been oiled, I have sorted the drive belt as per manual ...

...sewing machine shop Have a shop take a look at the motor. In my case it meant that the motor needed to be replaced. Borrowing another foot pedal is a very good idea, as that is often the issue. Try ...

...sewing a few inches I can use the machine to sew a few inches and then it slows down to crawl, to nothing, then after it cools, I can use it again for a few inches and then it does the same thing. We ...

sewing machine...my machine seems to be sewing correctly until I try to sew very fine lightweight fabric. I get a "birdsnest" on the bottom portion of fabric. Why? Most likely it is the top thread not

...receptacle. The carbon brushes in the motor might be worn or the motor control could be worn out. There are a number of possibilities, so you might need to take it to a sewing machine repair

machine sews ok if I sew slow. If I sew any faster, it makes an awful noise like gears grinding. Also, the pegs that holds the thread spools have gotten pushed down. How do I get them up again so they