Sew D'Lite Lightweight Portable Mechanical Sewing Machine "foot lever loose" Questions

foot lever Singer promise 1408 I have a singer promise 1408, I recently took it apart as the presser foot bar wont stay up when I lift the lever, now im questions how far high should it go or if there

...foot bar and pull it down.  It is likely that the loose bar has jumped off of the cam on the lever.  you'll need to figure out how to get in there and tighten it or replace a broken ...

foot lever not working sewing machine does it feel loose and wiggly?   A lever should feel firm as it works.  If it does you'll need to get inside.  Typically these levers have

...on the pressure bar and it is the piece the lever pushes on to lift the foot. If just loose you have to put it to where it needs to be on pressure bar to lift it high enough and tighten the set

...foot lever goes up and down but the presser foot does not. Singer sewing macine. There may be a disconnection between the lever and the presser foot bar. Perhaps a screw has fallen out, broken, or is ...

...The foot release lever (when pulled up) also releases the upper thread tension (at least on most Singers). Check that moving the lever also releases the upper tension. Good luck on your ...

...foot lever: Inspect the presser foot lever for any visible damage or looseness. Make sure the lever is not bent or broken and that it is properly aligned and connected to the machine. Check the ...

...foot stays down and the lever isn't working to bring it back up. How can I fix this problem? Is something just loose or broken? Dawn more than likeley the set screw is loose on the presser bar shaft ...

...foot lever is loose, is there a way to fix without taking it in for repair shop? It is a singer 5705 machine open he face and check the clamp screw. If loose raise foot to give 5/16" clearance and ...

...foot lever is loose and foot will not come down. How do I get inside the machine to see if lever is disconnected on this sewing machine Kenmore 10791. Circa 1988 Thanks the screw had come completely ...