Singer 3962 Mechanical Sewing Machine "getting threads bobbin compartment" Questions

bobbin compartment and since clearing the jam I can't get the bobbin thread to tighten up, it just keeps bunching up and tg\he bobbin compartment jumps out of place. I have a manual but it has

bobbin compartment might be pulled out of alignment. You might want to take the bottom plate off, clean off any lint and threads, and put the bottom compartment back in. Follow your manual if you have

...bobbin compartment. Open the bobbin compartment, remove the bobbin, then remove the bobbin compartment holder, jus pop up, then you'll see a spinning drum, if you observed on one side of the drum ...

bobbin, adjusted stich lenghts, cleaned compartment..?...Is this a timing issue or a part that needs to be replaced? I had the same problem where the thread was getting all bunched up on the underside

...bobbin compartment for loose thread and or debris. This often causes the thread not to combine properly. There is also a tensioner screw on the bobbin housing that can be tightened/loosened to adjust ...

...are ready to pick up the bobbin thread with the top thread. The bobbin thread will be drawn across the top of the bobbin and will be outside the bobbin compartment after the thread is pulled

getting hung up in the shuttle. I have taken it apart and replaced it at least a half a dozen times. What do I need to do? I have a necchi model 215a-b-bs and I have been unable to sew as when I do it

...bobbin compartment - urrgggg I tried setting the upper thread tension different to get different results however it seems the thread is indifferent and will jam according to it's own will. help. Take ...

...bobbin compartment. it broke off and i can't get it, can't really see it, but my entire machine is now jammed. i'm desperate. You can remove the thread jam by moving the hand wheel back and forth. ...

...to work .do l need a new bobbin compartment sewland sm1082 Tell us more information. When you install the bobbin and run the machine, what happens? Is the top thread not picking up the bobbin