Singer 5050 Mechanical Sewing Machine "put bobbin" Questions

...put the needle plate on before you install the bobbin case. You can lock the bobbin case down by putting the needle plate on after putting the bobbin case in. Take off the plate and remove the bobbin ...

...bobbin, put the bobbin on the pin and wind with the machine. The only problem with that is if your machine is finicky (like some computerized model), any thread hanging outside the bobbin may cause ...

...bobbin fast enough to put thread on it most likely you do not have the correct bobbin that fits on the bobbin pole. on the bottom of the pole there may be a small knub in which the small hole on the ...

bobbin. 4. Put the thread and empty bobbin into position on your sewing machine. Wrap the thread around the bobbin to start it. On most machines, disengage the needle by turning the smaller hand-wheel

...put the bobbin in the winder it seems to me that it is a little lose is it suppossed to be snug? please help. Thanks The bobbin winder question is a frequent one and it is very easy to solve. If you ...

...bobbin and put it in. It will only feed about 6" of thread before the bobbin thread breaks. It becomes so tight I can't get it to feed. Both bobbins will not feed. However I don't believe it's the ...

...Put bobbin in (rotating counterclockwise). 2. Put thread under the tension plate. Let the bobbin hang from finger and bob up and down lightly. 3. Adjust tension. The bobbin should extend one inch ...

...PUT THE BOBBIN INTO. I ORDERED A BOBBIN HOLDER, BUT THAT IS NOT IT. The bobbin fits into a bobbin case (holder), the bobbin case is what you take out to put a new bobbin in. The bobbin case fits into ...

ok, then when machine runs and then jumps to a different part of design the bobbin flips Hai, I think you put the big size bobbin. So only jumping the bobbin. Please try to put the correct size bobbin

...put the bobbin in its case then pull some thread out and pass it thru the bobbin case slot and under the tension spring .. put the bobbin and case over the shaft that is in the main unit .. the open ...