Yamata FY812 Mechanical Sewing Machine "bobbin thread pulling embroidery designs" Questions

...bobbin thread it shows on the topside. If I use a Janome, for instance, bobbin thread which looks thinner that's ok. I am sure this is a new problem. You should always use proper Bobbin Thread for ...

...bobbin thread coming through (currently using pre-wound ones bought from Husqvarna dealer in England). I was doing some embroidery today and everything was okay until I had to change the bobbin. As ...

...bobbin thread is sooo taut that if it gets cut, the bobbin thread just pulls out very easily. I've tried a different type of bobbin (polyester) and it is actually worse. The bobbin tension sounds ok ...

...bobbin thread, and pull itup. There should be a loop of thread intertwined with the needle thread. Usetweezers, your finger, or a straight pin to retrieve the bobbin thread that isvisible through the ...

...bobbin thread is coming up threw the embroidery design You need to loosen the upper tension until the upper thread no longer pulls the bobbin thread up. If your bobbin case has a hole in the finger, ...

...bobbin thread too short so that it can't make those nice locked stitches when it starts. You need to take off the hoop, open up the bobbin cover and use your stylus, the tip of a pair of scissors, ...

...Make sure to use bobbin thread for machine embroidery, it is heavier and pulls the top thread slightly to the back of the design. You could loosen the tension or use a double layer of

bobbin thread for the bobbin but I gernerally use the same as on the top so it will be the same. Are you using an embroidery needle? .As for your thread getting wound around the bobbin the only thibng

...bobbin , checking that you have the thread going the correct way. * replace the needle with a new one of the correct size for the weight of your fabric and the weight of your thread *remove and ...

bobbin thread to front husqavarna 4d machine is pulling bobbin thread (supposed to just be backing of design) through to the front.  design done yesterday was great without this problem