Question about Vanguard Heating & Cooling
...http://waterheatertimer.org/How-to-troubleshoot-gas-water-heater.html#intellivent http://www.thetankatwaterheaterrescue.com/forums/forum3/ Gene ...
Question about Procom Heating & Cooling
...gas water heater is still working if the pilot lights when held but wont stay lit, the thermocouple is shot, local hardware stores sell universal thermocouples. self explanatory to replace. if even ...
Question about Goodman Heating & Cooling
...Gas is being supplied to the unit I have a water heater thats working that runs off the same gas line Hi so it lights when you jump out the pressure switch , then it would piont to the prssure ...
Question about Goodman Heating & Cooling
...water heater... How do I accomplish this feat? turn gas supply on....turn gas valve to pilot....press down and hold to allow gas to come through pilot tubing.....light the pilot right by the thermal ...
...Water seeped through floor and furnace got wet. Now it wont light. IT Glows LED says normal operation. But nothing. Open up the unit to get to the control board. Make a short jumper wire and ...
Question about Dyna-Glo Heating & Cooling
gas thru so that heater wont light. Are there recalls? Where can I buy a replacement part? Heater is 2 years old, never lit. What's the pressure to the heater? It should be a minimum of 11 to 13 water
Question about Vanguard Heating & Cooling
...gas with no pilot. The good thing is that most ofthem are universal and most water heaters use the same one. And you can buy one for a water heater at lowes or home depot for about ten bucks. If you ...
...well. Again turn on the gas supply, spray or rub some soapy water on the fitting you tightened, depress the knob and hold it. The soap will bubble up if there is a leak. Fix it. Now light the
...water. Be sure you turn on your gas to check. Check the tip of your thermocouple. Be sure the tip is tapered and not burned through on the tip. If it is, you need a new thermocouple. Make sure the ...
...gas valve and find the wires up to the thermostat, the should be attached to terminals marked TH and MV or something similar. Jump the terminals. The heater should start. If not, you may need to ...
37 questions posted
Usually answered in minutes!
9 Questions
6 Questions