GE WSM2780W Stacked Washer / Dryer "stop spinning lift lid" Questions

...stop spinning when in rinse mode. As designed. To stop wash-mode aggitation at lid-lift, using the existing lid switch and other electrical components, is not easy and not recommended. I can think of ...

Washing machine stopped Stops at the end of the rinse cycle - won't spin or drain try lifting the main top up and down and listen crefully do you hear any clicking just before the lid closes??? im ...

stop lid open each time. If it does not spin each time then you have a lid switch problem. If it does spin each time then I suspect that your spin tube clitch pads are getting worn. You cna remove the

...lift the lid. check the lid also. it could have been damaged and the contacts were able to swap location or change status. it should be close contacts when the lid is close and open when the lid is ...

...switch problem , lift and close the machine lid and listen closely for a "clicking " if hte machine doesnt think the lid is down it wonk spin/ drain for saftey reasons. common issue broken lid ...

...spinning. After a timed period 3-4 minutes, the timer is supposed to pause, stopping the motor for a few seconds. When the motor stops again, the transmission shift to the spin cycle and when the ...

...lift and close the lid it sounds like something engages the motor and all is well untill the next spin cycle and i gotta do it again Hello, looks like your lid switch is on it's way out, replace ...

...works. Won't spin or agitate If you mean that when the unit should be agitating or spinning the motor is running, and you lift the lid causing the motor to stop running, it sounds like the

...stop the timer for it to start spinning. Once I do one of those things you can see the brake release and the basket spin, then I put the lid back down and it spins happily. I tried a new timer but ...

...when you lift the lid, you pause the motor and the transmission shifts. Close it and it spins. Replace the timer and you will be fine. If I can help further..... Waiting to hear from you, Eric ...