Question about General Electric Washing Machines
...bottom side of the machine? I swear somebody bent them on purpose but that's me. In any case, the tub had moved far enough that the bent tub bracket had slipped around the bent floor bracket. When ...
...bottom of the tub to the lower frame. The tub end of the spring is attached to a bracket that is screwed into the tub. In my case, the screw holding the bracket to the tub had vibrated loose, causing ...
...bottom between the tubs. There is a heater bracket, made of a thick wire inside. Make sure not to damage it when trying to remove whatever there is inside. Make sure the heater is aligned in the ...
Question about Fisher and Paykel Washing Machines
bottom round "bearing" onto the tub, lift the rod up and set the angled bracket back into the corner of the cabinet. if this angled bracket is still attached to the corner and you see a rod and spring
...tub aligned so it doesn't flop around. Another thing to do is adjust the feet on the bottom of the washer. It works best when you use a level on top of the washer and then adjust the feet so it is ...
...tub to bracket. If one is missing (which it probably is) look around in bottom of washer & locate it. All these bolts have to be very tight & this unit is bad about bolts backing out on their
...bracket on bottom of the tub.Are all 3 connected together?Thanks Ron Paynter [email protected] IF YOU ARE TRYING TO RE INSERT THOSE PINS YOU GOIN TO HAVE A HARD TIME.THOSE ARE CALLED TRANSPORT ...
...over the side of the right guide at the bottom of the washer and the guide was bent. i moved the motor bracket back to the correct side and bent the brackets back straight. Our washer no longer
...will compress and the tub will lower. There is not much of a gap between the shipping bracket and the bottom when the tub is loaded down so if the bottom was bent upward even a little, it could
61 questions posted
Usually answered in minutes!
992 Questions
874 Questions
371 Questions
398 Questions
323 Questions