GE WDSR2080D Top Load Washer "water pressure" Questions

...Water Pressure from House Supply If the washer is overflowing the water pressure to the water inlet valve might be too low. The water inlet valve requires a minimum of 20 psi to shut off properly. If ...

...water pressure too low; Drain tube improperly positioned; Water fill solenoid valve is faulty; Leaks from water circuit on pressure switch; Pressure switch faulty; Wiring faulty; PCB faulty. E13 - ...

...water pressure and flow for a admiral washer model #atw4676bq1? When the water pressure is low, the water flow is just less. When the diverter opens, it lets whatever water is there pass through, So ...

...water pressure above (30) psi? No, have customer correct pressure problem. Yes, check for kinked or blocked incoming water hoses, clean incoming water screens. If problem still remains, replace the ...

...pressure switch trips. The water valves are then turned off and the error code is flashed. The error code is also flashed if after 30 seconds the water valves are turned on and no water is detected ...

...water pressure is very low. The analog pressure sensor is a component on the machine control board. The normal water pressure is 100-200 PSI, when the pressure below 40 PSI then this error occurs. ...

...WATER PRESSURE REALLY SLOWS DOWN. I HAVE TO TURN THE FAUCET COMPLETELY OFF, THEN BACK ON AGAIN TO GET FULL WATER PRESSURE. I USE A BOILER DRAIN TYPE FAUCET AND HAVE ALREADY REPLACED IT AND THE COLD ...

...tube is clear, the pressure switch needs to be checked, replace if faulty. Low water pressure into the machine can also cause the inlet valve not to close properly, minimum pressure required is

water Pressure Switch to allow more water into the machine? water pressure is whatever the water pressure is at the faucet, the machine has no pump to increase the pressure, no washer does. there is a