GE WSXH208A Front Load Washer "water filter plug leaks" Questions

...water to run into the bucket, clean filter, check the gasket, as it may need replacement (if so, replace it), then screw white plug back in, push plug back into unit, secure the rubber feet, and ...

No other untoward problems. Any reasons for problem welcome. When the filter clogged, drain pump could not drain all water and always some water remain in. after cleaning, the problem will not occurs

...water from the front filter plug. I have unscrewed it, cleaned it and put it back but it still leaks. It leaks mostly when the washer is emptying. There doesn't seem to be anything else I can remove ...

water level and fills to capacity. what to do? Maybe its not draining completely? Have you tried opening the front panel, pulling out the white plug, putting a bucket under it, unscrewing the front of

...filter plug back in, the water still leaks, hoover optima wash wmh148df-80 Hi from retired Englishman in SW France, I suspect there is either limescale in the thread of the filter plug OR behind the ...

filter. 4 Once all water is removed from the washer, the pump filter can be unscrewed by turning counter clockwise (typically 3 full turns), then pulled out of the filter housing. 5 Once removed, wash

the plastic lid or case. Make sure the clamp fits tightly. If water does not flow from the drain hose properly, try 'back-washing' the filter element--you may have to replace it if you have difficulty

...water to leak out. remove the inlet connection and check the free flow, check the inlet filter and the valve, check the connectors for right mating. If there is leak then you must use teflon tape to ...

front door leaks While wash cycle is on water is leaking from the door Check to see if your filter is plugged

...the water from the filter plug dribbles under the machine, and sets off the water leak sensor. Remedy: as already advised. turn off machine. Tip forward to allow water to run away. Turn on