washing machine drum bounce around? Had a look could it be the shock absorbers on the bottom of the drum gone? i had same problem but i was terrible at balancing loads......also being a male i tend to
Washing machine leaks on spin Last updated on February 6th, 2017 Sometimes a washing machine leaks on spin, but not before. If this is the case, either it's going into spin with too much water inside,
...washing machine sound like its going to take off and bounce along the floor when its on ths spin cycle It is the dampers on the underside of the drum that have failed. There are normally 2 dampers. ...
Question about Electrolux Washing Machines
...machine. If one of those are broken when it goes into high speed spin ght thing will bounce around violently. Also the tub hands on springs from the top. Its uncommon but one of those could have ...
Question about Washing Machines
...going bad. If not spin the tub by hand and see if its stuck if it is work it back and forth and see if you can break it free. That is still a bad bearing. Also try spinning the basket by hand as fast ...
Question about LG Washing Machines
...problem, it spins slowly then will not spin fast, it bounces clothes together go to the bottom of the machine nd check if u have a swoolen or crack on ur capacitor or ur floor level is in ...
Question about Crosley Washing Machines
...washing machine (older top loading model) will finish the rinse cycle then stop. The timer keeps going until the end of the cycle but the water does not drain and it does not spin. The dial has to be ...
Question about Frigidaire Washing Machines
...machine just shuts off. Hi, This sounds like it is either part of the motor that is burnt out, or a fault on the control board that controls the fast spin speed. The motors have a number of coils, so ...
...spin mode Sounds like one of the springs going from the tub to the frame could be broke or unhooked. Also, the washer could be out of balance. The tub is out of balance. When it starts hitting the ...
LG Front Load WM1815cs Makes loud noise when spinning. Inner tub is loose and seems to bounce making loud noise. Is this more than a bearing problem? The outer tub and the bearing will need replacing ...
1,215 questions posted
Usually answered in minutes!
992 Questions
371 Questions
398 Questions
323 Questions
255 Questions