Sanyo DP42848 LCD TV "trouble shooting always" Questions

...trouble shoot Your unit has a defective LCD panel. If the unit is not under warranty, the LCD panel itself will cost you about as much as the tv. Best solution is to replace the tv with a new one and ...

trouble shooting in thr back see if you have it. make sure cable connection is good or HDMI. Depends, did TV have sound at one time, and now it doesn't, or is it a new TV, then set up may be required,

trouble shooting a Samsung LCD TV model LN40A530P1F and I believe it is the power supply. I am familiar with underrated 10 volt 100uf caps on some models. I?ve changed the suspected caps, this TV does

always been extremely helpful to me. BUT - remember to be polite! As the old saying goes you get more flies with honey than vinegar. I am almost certain those who are rude do not get the superior help

trouble shooting tips? if the problem is always red picture every time you open your TV unit i may say that there is problem in your CRT chassis board or at chroma driver. open your unit then pull out

...trouble shooting this problem. Thank you. U have basic electronic skills?Have all the tools?Take the tv aparts,the board where the power a/c plug into it.That the power supply board,check for these ...

...trouble shooting LOGIC). You always want to be able to back track... to a known failure state. All your "NEW" circuit boards are also unknown suspects... so while you are trouble shooting... if you ...

trouble shooting every six second always turn off him self This is cause by your inverter. When they go bad you will either have a dim screen or intermittent screen flashes. You will need to call the ...

...trouble shooting now if you do it with your own make sure you have proper tools then at least have basic knowledge in trouble shooting and then always observed safety since you are dealing with high ...

...trouble shooting. then check the normal connection of all the connectors and then look for the back light if their is a maldischarge from the module.disconnect all the connectors to isolate excessive ...