Sony KDL32L5000 32 in. LCD HDTV "mov circuit" Questions

...circuit board no obvious damage You have to change the power supply bord. If fuse blows off then the smps driver section is faulty. Also there is possibility of faulty MOV . MOV metal oxide verister ...

no power at all. the antenna was struck by lighting. The main fuse and the MOV's (surge protection component) and a lot of circuits (main board, tuner module where the antenna is attached to). ...

circuit lost the neutral wire. The voltage going to the tv was 250 volts between the hot and the neutral. The tv will not turn on and it it doesn't even have a power available light. I did look inside

...surges. mov is metal oxide varistor, a resistor that shorts out when the voltage rating is exceeded causing the fuse to bluw. always right after the fuse on the circuit board on the powersupply ...

...circuit with the power switching regulator section. Check the MOV [Metal Oxide Varistor] connected accross the main AC power line, on board. This device will look like a ceramic capacitor, usually ...

...blow the fuse. Once MOV blown, it will more likely stay short circuit, if you put the new fuse in it will blow the fuse right away. You need to see if the MOVs blew up any sign of blown up

...power supply board for the replacement. It may blown the fuse since the surge protection devices (MOVs) are connected to the incoming power after the fuse inside the TV, the MOVs may have turn on