GE JSP26 Electric Kitchen Range "electronic stove clock" Questions

...stove is a kitchenaid superba glass top Short circuit detected; oven temperature sensor. Check sensor for normal room temperature resistance (1085-1097 ohms at 75 degrees F). Check wires between ...

...Stove went pop; now flips wildly from broil/clean/lock. None of the electronics ont he control panel work--clock, back, off, on, etc. need toreplace your erc which is your clock it runs ...

...electronic stove. Wehad a power outage. How do you reset the clock To set the time. The top strip on the upright part of the stove , where the clock is, flips up. The directions are under it. oven ...

...stove Gain access to the back of the clock (electronic range control or ERC). Unplug the touch pad ribbon connector from the ERC. This will be a flat wire apx. 1 1/2" to 2" wide. Make sure everything ...

...stove fuses, they look fine - including the one for the oven. Any suggestions would be greatly appreciated. Thank you Zena Pendlebury you have a bad electronic oven control or in other words bad ...

...stove. All the fault codes I could find on Roper indicates that this is an Electronic Oven Control (EOC) failure. This is your clock assembly. Searspartsdirect.com carries the part for about $47. I ...

range model 790.90152300 the clock and oven does not work. the stove top burners work. The clock and oven controls are electronic. The electronic oven controller has failed. The cost is around $160.00

...stove no longer lights up or works Dear Realtor, If 120V is reaching the clock than the problem is caused by the clock.We repair mechanical and electronic clocks,timers and controls for major ...

...stove Range Setting the Clock and Timer Non-Electronic Clocks: To set the clock, push the center knob in and turn the clock hands to the correct time. (If the Minute Timer pointer should move also, ...

...stove junk?? you will need to replace the control board that contains the clock readout,any power surges ruins these electronics instantly,this can be replaced by removing the rear cover on the back ...