...oven, Set probe temp to 100, Start the Bake cycle. Target probe temp will hit 100 in minutes, Open door, Take out Probe. Your done - solved! I think this started when I accidently tapped Probe when ...
...oven temp sensor or the oven temp. sensor itself is bad and should be replaced. To solve this issue test the oven temp. sensor, it should read between 1080-1120 ohms, if the rating is more then that ...
oven temp. In this case you would have to ohm out the temp probe. 3. The control itself may have a shorted relay-replace the control. The temp probe should ohm at approx 1100 ohms at room temp. Unplug
...oven temp for 275 degrees, but maybe any temp over the probe temp would work. 4. Then start. The cycle took 12 minutes to complete, and when it was finished, turn the oven off and then open the door ...
oven temp probe,and or the main electronic control board. Be sure to check the wiring to the temp probe and the control.If everything is ok the least expensive thing to replace first is the temp probe
Question about KitchenAid Kitchen Ranges
...temp to 165, set the convection (or bake) oven to 500, and turned it on. This allowed it to run for about 20 minutes, and cleaned out the probe jack. Works fine now. Remove the left panel of the oven ...
...oven temp has a wide degree swing. The oven is about 80 degrees off to the cold side. I can set the temp up abur 80 degrees and it will reach set point 80 degrees lower. Then the temp will vary 50 to ...
...oven quit working in the middle of using it. The baking and broil element won't heat. I can turn on the temperature and it will click like it is trying to heat up but it won't get hot. We have tried ...
oven is in temp runaway and just gets hotter and hotter, always on, then there is a failed component. If the temp is just somewhat hotter but is still being controlled then there is a user temp offset
Question about KitchenAid Kitchen Ranges
...oven temp sensor or the oven temp. sensor itself is bad and should be replaced. To solve this issue test the oven temp. sensor, it should read between 1080-1120 ohms, if the rating is more then that ...
12 questions posted
Usually answered in minutes!
1,163 Questions
390 Questions
104 Questions
83 Questions
77 Questions