GE GSS25SGMBS Side by Side Refrigerator "resetting compressor fridge" Questions

...Compressor on a Fridge Locate the refrigerator power cord on the back of the appliance. Disconnect the power cord from the wall outlet. ... Turn both the fridge and freezer controls to "Off" or "0" ...

...compressor now is very hot switched of the fridge Check the Control Settings: Ensure that the temperature settings for both the fridge and freezer compartments are appropriately configured. Sometimes ...

...for a few hours until it cools down. If you keep trying to use it, the compressor will fail again. They have a self resetting thermal cutout but these will fail if the compressor keeps

...compressor is not running lights are on in fridge so it must be getting power is there a reset switch damage was caused by electrical problems, you can check from Thermostat, whether still working or ...

...fridge if there is not heat then the compressor is not working call a technician as it could be a start/run capacitor failed or compressor seized get a quote as some compressor replacements cost as ...

...fridge of that age I would think that the compressor motor has died. It may be a capacitor if it is outside the compressor housing or an overload switch that can be reset but you will need a fridge ...

fridge seemed just fine, I heard the compressor start, all seemed normal. I closed the doors and set about reading emails. About 10 minutes later, the breaker tripped. I would not reset. By process of

fridge or freezer door , the compressor is not that strong to maintain the required temperature.So its working hard to cool inside temperature, but its not doing it quickly as it should.---------.----

...on for a few seconds then click off. Staying at about 52 degrees over 24 hr period in fridge/freezer. either the relay on the side of the compressor is faulty or the compressor hs short ...

...fridge and freezer. It has power, is there a reset button for the compressor? NO there is not , call a repair service or replace it Most likely control board is bad if compressor isn’t running at