GE (PSS26MSRSS) Side by Side Refrigerator "refrig door seal properly" Questions

...door open. The light would turn on/off every few minutes. I did not turn the refrig/freezer off but instead dialed the refrig to "1" (warmest possible setting. Now the fan (compressor?) ...

...refrig walls brand new kenmore, lots of condensation Either the door gaskets are not sealing properly or the doors are not completely sealing. The moisture is from air entering the refrigerator and ...

...door and seals, does it close and seal properly. If the seals are letting in warm air, the fridge goes into overtime, hence freezing up. Its also worth checking that the fridge isn't on too higher ...

...refrig model # 10645423801 cannot remove ice storage bin When I press the side button on the space saver ice system as directed, I am not able to lift and remove the ice storage caddie Could it be ...

...refrig door is not sealing tight about halfway down the door. Is there a adjustment I can make to help to door seal properly? Hello, Check to be sure the frig is sitting level. You should have ...

refrig door not closing properly, needs a push, DOOR IS NEEDING HINGE ADJUSTMENT. LOOSEN SCREWS IN HINGE, ADJUST DOOR TO ALIGN WITH SEALS AND TIGHTEN SCREWS TO RE-ADJUST.

DOOR SEAL LETTING AIR IN AND CAUSING FAN TO OVERWORK ITSELF. ANOTHER CAUSE CAN BE DIRTY COILS AND CONDENSER AND LASTLY NOT TO COMMON IS A SHORT IN THE FAN SYSTEM ITSELF. A MORE PROBABLE CAUSE COULD BE

...door does not seal all the way I have had this Refrig for almost 3 years and have had a few issues along the way but here is the latest. Lots of frost build up and after a closer look, the door does ...

...refrig door and the freexer door is hot. Heat the seals with a hair dryer and then pull it tight - strap it tightly shut - you can also use some super glue to keep it in place while it dries. Gary @ ...

Refrig door does not seal Fresh Food door does not seal on bottom handle side. Gap between closed door and refrig is 5/16 inch greater at bottom than at top on handle side (1+5/16 on bottom vs 1 on ...