...control switch located on the furnace just below the plenum. If the plenum gets too hot, the limit switch shuts off the burner. It also shuts off the blower when the temperature drops to a certain ...
...switch is good but control board is bad. Control board code is 80M2701....any ideas? That control board is several hundred dollars. If I may make a suggestion, take a jumper and when the inducer fan ...
control because the relay/switch in the heater is stuck in the "on" position. If you have the schematic for the thermostat/control then you can figure out how to simulate the control signal that would
Question about Heating & Cooling
...switch or control relay Confirm that the FAN (auto/on) switch at the thermostat is in the auto position. I have cycled between the auto-on positions on the thermostat and confirmed that the control ...
control in one-hour lockout) 2 Flashes: Pressure switch fault, fails open (switch is stuck open) 3 Flashes: Limit switch open (main or auxiliary) 4 Flashes: Pressure switch fault, fails closed (switch
control switch and the pressure switch? How often do gas valves go bad? Could it be that the gas valve has stopped working? OK, if the furnace is not lighting for even a few seconds, you have either a
Question about Goodman Heating & Cooling
...switch Gas valve solenoid have continuity? No continuity replace the valve Getting 24 volts to the gas valve? No voltage from control board check fuse on control board. Replace control board. Any ...
...wiring for on-off switch I have a Lakewood heater that has 7 fins excluding the front where the controller is mounted. I need a wiring diagram for the on-off switch. I have a bad switch, removed ...
switch or limit control. The pressure switch and limit switches are there for your safety. If you have an open limit control either the furnace has over heated or the limit has gone bad. Problems that
Question about Goodman Heating & Cooling
...control), the inducer does not energize (bad motor), the pressure switch does not close (blocked vent piping, bad switch, plugged condensate hose), the ignitor does not energize (bad control, bad ...
29 questions posted
Usually answered in minutes!
141 Questions
45 Questions
30 Questions
20 Questions
8 Questions