GE JTP15 Electric Single Oven "bake relay" Questions

...Bake relay. if either one is bad, or not energizing, you won't get any power to the bake element. (The bake element runs 100% of the time during the bake cycle. broiler only operates 25% of the time ...

...one is out, you won't get squat for heating - the problem is most likely with the DLB relay or the bake relay on the relay board. (The element should ohm out between 20 and 40 ohms if it's

...Bake mode. Must be the relay board. I want to know what relay is involved in powering up the bake element. What are the terminals to test Like DLB, BA and L2? ...

the control board if you can't hear the relays on the board clicking when you power up the elements bake or broil then its either the low voltage side of the board,if you hear clicking then the relays

...elements can be tested with an ohm meter for continuity. There is a relay in control / clock for both bake and broil elements. If elements test good, then those relays need to be tested for

...bake relay is fused. Depending on the brand and model, the bake relay can be located on either a realy board or the electronic oven controller. Either the controller or the relay board (if present), ...

...hot. When on bake, it get's to 200-245 deg. OHM test showed bake element ok (19) thermostat is bad If bake element is not getting red hot, either the element is bad or the relay on the control is

...the relay board have failed. If this happens replace the relay board. The relays on the board are not sold separately.ALSO CHECK THE BAKE AND BROIL ELEMENT. : I offer free advice bcuz God is so

...bake and broil wires on the power relay board. They will be marked BA and BR. Fire the oven up again and if the bake element comes on then you know that the broil relay is stuck or shorted. Without ...

...relay on board. Run oven and check to see if bake element is cycling off when it reaches temps. It should stop glowing within 15 minutes from start. If it doesn't you need a relay board most