Lasko 3300 Wind Machine¿ Floor / Box Fan "disassemble tri blade" Questions

...dirty bearing condition is verified. To properly clean the shaft and bearings, the motor must be

Is there a means for a technically competent handyman to lubricate the bearings of the lasko wind machine 3300? The fan and motor are both easily disassembled with a Phillips screwdriver and some ...

...blade from the motor. There might be a set screw on this one. Some just pull off. Once you get the hair removed, confirm if the shaft is easy to turn with your fingers. You can oil the front bearing ...

Patton 1887 fan blades wont turn I have a Patton 1887 fan. The motor is  humming but the blades won't turn and feel tight. I tried a few drops of oil but still won't work. I think I need to take ...

oscillating table fan makes banging noise when rotating I have a Sanyo tri-speed table fan which works great. However, recently, when I tried pushed down the oscillation knob for the fan to rotate, ...

...is lost. Can I buy a remote transmitter without knowing what kind of receiver I have? Or how do I disassemble the fan to get at the receiver to replace it and the transmitter? Thanks for any advice ...

disassemble fan for cleaning? I can't figure out how to remove the front half of my fan casing, in order to get inside to clean it off. The two halves were obviously snapped together and it seems like

...bench,and some high temp bearring grease) to take things appart in general, you should be able to disassemble the fan motor and either pull bearings off shaft and replace or repack w/high temp ...

...disassemble and clean/lube. Most fans are in danger of tripping a hard to replace, buried thermal fuse. When you hear your fan struggling, understand that you may loose it for good if you trip this ...

...motor or sewing machine oil. This seems to give a longer solution... heatman101 The cheap fans I've disassembled have had only a small smear of rather stiff grease dabbed on at the bearing. I've ...