Question about GE SpaceMaker Microwave Ovens
...YOU CAN TRY REMOVING THE GLASS TRAY AND TURNTABLE AND REPLACING IT WITH YOUR OLD GLASS TRAY (IF YOU HAD ONE) OR JUST ANY GLASS MICROWAVE TRAY. WITHOUT THE TURNTABLE, I CAN'T SEE HOW IT CAN
Question about GE SpaceMaker Microwave Ovens
...glass tray that you were referring to. The following link explains how to access and replace one: http://www.fixya.com/support/r3555716-replacing_a_turntable_motor_on_a_microwa This is a very simple ...
...glass tray, and there is the small plastic coupler that the center of the glass tray is supported by. The part numbers are as follows: Carousel ring - WB06X10513 Coupler - WB06X10564 You can view and ...
...glass tray over the turntable guide and onto the drive bushing. The drive bushing should fit neatly into the grooves on the bottom of your glass cooking tray. It may take some adjusting before the ...
...glass plate or tray from the microwave oven. Check to see if spilled food particles are caught in the roller wheel that supports the glass plate. Clean the inside of the microwave, particularly the ...
Question about GE SpaceMaker Microwave Ovens
...glass tray and carousel ring. 3. Locate and remove the screws holding the bottom panel (under the microwave) in place. With the screws removed, the bottom panel should open. 4. Disconnect the ...
...when I remove the glass tray the unit turns but very slow. The problem is in the turntable motor it has become defective "common issue in a number of brands" the only solution is to have it
...glass tray sits on. You may have to gently pry up with a flat screwdriver to get it to come loose. 6. With the coupler removed, loosen the mounting screw(s) to the motor and it should easily come out ...
Question about GE SpaceMaker Microwave Ovens
...glass tray and be sure all is clean and dry. If something did blow up (food or liquid), find the small mica window on the inside, and carefully remove it, clean up, dry off in the cavity too, and ...
Question about GE SpaceMaker Microwave Ovens
...glass tray sits on. You may have to gently pry up with a flat screwdriver to get it to come loose. 6. With the coupler removed, loosen the mounting screw(s) to the motor and it should easily come out ...
4,203 questions posted
Usually answered in minutes!
257 Questions
57 Questions
46 Questions
27 Questions
23 Questions