...mesh is a filter screen to keep the microwaves in the oven while letting you see the food. The plastic sheet that's peeling off is meant to keep that screen clean. It's not supposed to be removed, ...
Question about Roper Microwave Ovens
...mesh on my roper microwave oven That I would leave up to the professionals. If you are geting moisture or debris inside the glass then it is malfunctioning and needs professional repair. Call the ...
Question about Microwave Ovens
...mesh inside. I cleaned it up. Doesn't seem to affect the use of the microwave. Where do I order the film? Would clear tape over top of it prevent the hold from getting larger? Microwave are dangerous ...
mesh"(thats typical of micros) on the INSIDE.I can't figure out how to clean the spots off the glass.I tried to take the door apart to remove the glass to clean.I can't figure out how to seperate door
...inside. Please shed some light on this problem. Thanks, Mat. if you are not a tech kindly take your microwave to a tech for repairs.the diodes or the cap high voltage is your culprit.good luck. ...
...inside flickers and pops like it is going to explode? Sadly, we hear of this over and over. This is usually due to a defective or loose magnetron causing electrical interference and disruption in the ...
mesh RF gasket was not installed or got pinched. It may also need a new high-voltage diode and stirrer, and the cavity may be affected. GE had a campaign (but not a recall, mind you!) covering several
mesh RF gasket was not installed or got pinched. It may also need a new high-voltage diode and stirrer, and the cavity may be affected. Details are in a bulletin at http://207.234.249.73/mwd/ge_mw_mag
mesh RF gasket was not installed or got pinched. It may also need a new high-voltage diode and stirrer, and the cavity may be affected. GE had a campaign (but not a recall, mind you!) covering several
...repair GE circuit boards, but the problem is not your circuit board. This is due to a defective or loose magnetron causing electrical interference and disruption in the control circuit board. If your ...
377 questions posted
Usually answered in minutes!
3,405 Questions
567 Questions
285 Questions
257 Questions
258 Questions