GE JVM1440 Microwave Oven "change power hotpoint" Questions

...Hotpoint / GE owner's manuals and installation instructions here. It will cover changing the bulbs. A circuit board failure can occur if a bulb goes out and the filament shorts, or if the bulbs are ...

hotpoint RVM1425 I heated a muscle relief heat pack in the microwave. I think it's filled with sand?? After that the microwave wouldn't heat anything. I still have power and the glass plate still ...

hotpoint microwave light won't go off after I changed the bulb. We see (and repair) this a lot. The problem is on the control panel, which we regularly repair nationwide by mail for $39.95 ...

...Hotpoint owner's manual here. Another first thing to try is a "hard reset". Unplug it from the power line for a few minutes, plug it back in, set the clock, then try again. It may default to English. ...

hood light does not work or vent hood fan i changed both light bulbs, changed the thermal fuse and the capacitor is fine We see (and repair) this a lot. The problem is on the control panel, which we ...

...change the power level. This will come on in the middle of the night and sometimes be going intermittently for hours. Other times it will not happen for a couple of weeks. HELP, PLEASE. GE spacemaker ...

...to the breaker size and wire size, it pulled to much power to be on that circuit. So change the fuse if that does not work and post here and will see what else to check, and please rate if this

...change the fuse? On most GE/Hotpoint models, the control panel assembly will either tip down, or pivot sideways for access to the components behind it. Screws holding the top air deflector might have ...

...power line for a minute, plug it back in, set the clock, then try again. If you don't have your owner's manual, you can download it free from GE/Hotpoint. Please reply back if you need more help. ...

...power cord around. If you notice any change in behavior, most assuredly you have a problem with the cord itself or where it is connected in the microwave. If not that, unplug it and open it to see if ...