...foot well of the spa. Its easy to locate when you are in the spa.To fix.Check that the sensor has not been disconnected from the board or at the thermo-well end. If it was connected disconnect and ...
My Navigator stopped working---it just sits there. I replaced the foot pads---still nothing!! if you have enough suction and it still does nothing, even after replacing the shoes, it probably needs a ...
Question about Sunpak Pool & Spa
...of befor and after truly the same? With infrared the intensity of heat is devided by 4 every foot further
...board only shows green LED lights. Prior to not firing water temp was 120 degrees. Almost burnt my foot off. Next day heater did not fire at all. Where can I go to test control board? Live in Long ...
Question about Hayward Pool Products Pool & Spa
...Hayward as well as other manufacturers make units to operate from sea level up to about 2000-3000 foot and units designed for higher elevation. It has to do with burn rates and proper gas mixture ...
...line. These heaters work on gas volume more than pressure. For a 400,000 any thing more than 30-50 foot you will probably need at least 1.5 to 2 inch supply line. It is always good to go big on the ...
...filter (no indicator other than low pressure). Here are some useful numbers for your 4 X 12 X 30 foot pool: 1440 cubic feet or 40.776259104 cu meters 1 cubic foot = 7.5 gallons or 1 cubic foot = ...
...- Do NOT drain all the way to the deep end. Drain in 3 parts. Place pump into shallow area about 1 foot lower than the shallow floor. Then drill a hole all the way to the earth below. Then move pump ...
1 questions posted
Usually answered in minutes!