Rinnai Desa Vent-Free Infrared Gas Heater: Vent-Free Infrared Gas Heater(18,000 BTU) "clean stove burner holes" Questions

...stove works great again, but only for a week or two. Gartyl, Your Laser 55 burner mat has erroded away. The fuel is pooling someplace in the burner rather than spreading smoothly over the bottom. The ...

Flame goes out Monessen Ventless fire place Model DLX24. After lighting the pilot and turning on the burners the flame goes out in about 10 minutes. I have cleaned the unit and have no problems ...

...go 3 years between cleanings without any ill effect. If you get your stove running, run it hard on High for about 2 hours to clean and burn all the carbon out. Good Luck! toyotech, North Pole, ...

...stove installed. Hope someone can help with this. Thank you. If your fuel was yellow it was #2 home heating oil. Toyotomi Laser heater run well on #1. Since yours in giving you a EE10 message you are ...

...stove works well except it will go out on its own then I have to relit pilot . It does have some age on it. I have taken file boared to clean tip of therm coupler and just tap on it and it may stay ...

...dirty filter on tank and stove. Monitor 41 reads E-01 what does it mean? no fuel is getting to the pump clean pump filter and line filters hope this helps.       E 13 ...

...BURNER IS SHOT THERE ARE NO LITTLE HOLES IN IT LIKE A GAS STOVE OR GRILL IT IS A SOLID OPEN GROOVE IN THE THREE BURNERS AND DOWN TH ELENGTH OF THE BASE? PILIOT LIGHT LIGHT ONCE AND NOW I GOT TO LIGHT ...

STOVE SHUTS DOWN THE PILOT GOES OUT AND I HAVE TO RELIGHT PILOT sounds like thermocouple might be loose. The thermocouple where it goes into the control valve is probably loose and losing contact. The

...stove laser 30 would not ignite. I was getting ee2 which means out of fuel. I fixed the problem and now it is regerstering ee22 which my manual says is an igniter problem now I can't get it to even ...

...clean the nozzle. Just insert it an inch or so into the burner, not much further. Make sure you hear the blower start when you turn the heater on. You would get an EE 8 code if it wasn't. Let me know ...