Rinnai RHFE-1004FA 38,400 BTU Energy Saver Ductless Heater - Natural Gas "set temp" Questions

...set temp is being read from the thermostat or is there another thermometer in the room your looking at Is there a setting on your thermostat that makes the unit stay on for 10, 15, 20, 25 minutes ...

...setting. Set your temp. Then C will flash, this cool temp. Set your cool temp. After short delay stat will go back to display room temp. Red light heat is on. Green light cool is on. Hope that ...

...temp does not raise above what its set to but does not shut off very often when the temp is the same. the temp coming out of the vent should be 20 to 25 deg more then room temp and if AUX heat kicks ...

...set temp but fan continues lowering temp Problem started at the end of last winter season when burners shut down at set temp but fan continues to run lowering home temp far beyond start-up temp. Had ...

...set temp, the green light does not come on.It is my understanding that green light comes on when set temp reached. Is this wrong? This is at operationa lamp button... Green light is for power on red ...

set at a temp for Example ( 72 ) and it is not reaching that temp to shut off then you have a problem with your unit or insulation in house. If you set stat on cool at 72 and the house gets down lower

...set at 70'-will go to 70' if temp outside is in the 40's. if outside is in 20's, will only kick in if inhouse temp goes below 65'. If around 15' outside, will only kick on if thermostat inhouse temp ...

...in the room as you know most heaters do not run continuously, they cycle on ambiant temp. the boost setting is actually tweeaking that cycle, you are actually setting the vairence in the temp setting ...

set temp.3 the temperture icon will stop blinking and the current room temperture will appear after desired temp. is set.4 the heat will turn off shortly after the desiredtemp. is reached and the temp

...won't go up past 75 degrees Switch to cool and set the temp higher. Problem is it will not let you set the heat temp above the cool setting because would cause a conflict if tstat is set to auto