...fan blades i want to remove the blades of my ceiling fan but i can't seem to do it. looks like there's a cap or sort of cover that can turn. done that; but i can't seem to pull it out or take it out. ...
...Fan - motor will run but blades will not turn. Does the motor spin, but the blade is not turning? The motor has a D shaped shaft. If the hole in the blade that the shaft goes in is rounded, then the ...
...fan blades, it sounds to me like either (a) the pin somehow came out, or (b) the slot in the blades is rounded. Hope this helps see if the fan blade set screw is tight and if it is then see if the ...
Question about Hampton Bay Dryers
blades off my table fan to clean them and once i put the fan back together and turned the fan back own the blade spins and everything but no air is blowing out its a cool breeze 13 inch velocity fan I
blades to fan before operating. 2. Check to make sure all screws in motor housing are snug (not over-tight). 3. Check to make sure the screws which attach the fan flanges to the motor hub are tight. 4
...fan is turning freely replace the front cage with all the screws plug the fan and I hope this solves your problem. You may add 3 in 1 oil or some other very light lubricating oil periodically. I hope ...
...fan blades over to other color I want to turn over the fan blades to the reverse side color On most fans, each blade is held on with 3 screws. Sometimes a rubber grommet is included in the mounting ...
volt current to the motor because anything less will cause that problem too. You can also help the fan start by spinning the blades while it is on. Short of these suggestions, it is time for a new fan
3 questions posted
Usually answered in minutes!
57 Questions
19 Questions
19 Questions
1 Questions
2 Questions