...the two wires to the element,now replace the two wires to the high limit switch,replace the back panal and the power cord cover,replace the vent hose,plug power cord in and check element
...I failed to label wires. Each part just has two wires but I do not know which one goes to which hookup. For these two items ther is no order for the connections. you can just hook them back up. ...
...wires from the termal fuse and hook them together with a papper clip or just tape them together make sure it doesn't touch metal. (this will short it out) and then plug up the dryer and try it to see ...
...back in place and connect the element wires before putting on the cabinet cover. Step 6 Run the dryer on fluff with no heat, and go outside to make sure enough air is getting through the vent system. ...
...back in place and connect the element wires before putting on the cabinet cover. 6 Run the dryer on fluff with no heat, and go outside to make sure enough air is getting through the vent system. 7 ...
...back of the unit. The heat section is in the bottom left. There is a large tube hooked to it and you have to remove that first. You might then be able to get the wires of your volt meter in and check ...
...hook it back up the right way WELL IS THERE TO RED WIRES AND AN ORANGE WIRE TO ELEMENT RED WIRE COMING FROM TOP WIRING HARNESS GOES TO THERMOSTAT ORANGE WIRE GOES TO OTHER SIDE OF THERMOSTAT AND RED ...
...be a wiring diagram inside the console of the dryer that shows which wires go where, but I am sure you have crossed the 2 wires below the hi-limit switch.Post back if you need any ...
...the heating element and up above that theres a sensor that has two wires to them.if thats bad you can replace it or you can just hook the two wires together and bypass it and it will cost you
192 questions posted
Usually answered in minutes!
1,329 Questions
1,410 Questions
750 Questions
524 Questions
182 Questions